Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Weir flow is calculated using the following formula:

where

Q = Discharge

Cd = Discharge coefficient

b = Weir width

h = Water depth


Weir: Specification 

Coefficient of Discharge - The discharge coefficient depends on the type of weir or flume chosen. A default value of .544 is given and is generally suitable for flow over a flood bank, round nose horizontal - crested weirs and rectangular flumes. Other values may be used and as with the other controls, values for discharge coefficients may be found in any good reference on hydraulic control structures.

A selection of the more common coefficients is given below.

 

Description

Coefficient

Reference

Image Modified

A round nose horizontal-created weir (or flow over a floodbank)

0.544

British Standards Instn (1969)

Image Removed

Image Added

A rectangular profile weir

0.46

Ackers, White, Perkins, Harrision (1978)

British Standards Instn (1969)

Crabbe (1974)

Image Modified

Rectangular thin-plate weir full width b with no side contractions

0.59

Ackers, White, Perkins, Harrision (1978)

British Standards Instn (1965)

Image Modified

Rectangular thin-plate weir with side contractions.

0.56(b +.003)

Ackers, White, Perkins, Harrision (1978)

British Standards Instn (1965)

Crest Level - The crest level of the weir.

Width - Enter the width of the weir. If you are working to a maximum allowable discharge then a Calculator is provided to help size the control. This gives two additional parameters:

Image RemovedImage Added

    • Design Depth - Enter the maximum depth of water that you are designing to. This should be entered as a depth above the invert level of the control and will vary depending on the depth of the stormwater control and the desired freeboard.
    • Design Flow - Enter the required flow when the water level reaches the design depth. This should be the maximum desired discharge through this control. Be aware that if the water level is lower than the design depth, the flow may be lower than the design flow and if the water level exceeds the design depth the design flow may be exceeded.
    • Coefficient of Discharge - Enter the discharge coefficient of the weir.
 


Scroll pdf ignore

Quick Link
imagecheckbox_checked.png
linkHelp+Documentation
titleBack to: Help Documentation
 


Section Pages

Children Display
depth2
pageOutlets
 



Workflow - What's next...?

Connect Inflows to your Stormwater Control, specify Weir or Outlets or connect to another Stormwater Control or Junction.